In order to use the 100Mbps SFP transceiver, please follow the below setup:
1. Please unplug the transceiver
2. Enter into the interface mode
3. Issue the below command:
Console(config-if)#media-type sfp-forced 100fx
4. Insert the transceiver into the switch
5. Repeat the step 1 to step 4 on another switch
6. Connect both switches using the fiber connection
== Finish ==
Wednesday, July 1, 2009
Subscribe to:
Post Comments (Atom)
No comments:
Post a Comment
Note: Only a member of this blog may post a comment.